Toshiba B-415 5. ATTACHING THE SHOULDER STRAP

E4-3

4. LOADING AND REMOVING THE BATTERY ENGLISH VERSION EO1-33014

The charging time may differ depending on the condition of the battery pack or the temperature of

the environment.

• Using the battery pack at once

Remove the battery pack when required. It can be used even if the charging is not completed. Bat-

tery operating time, however, may differ depending on the charging time.

• If the ERROR lamp flashes

Check as follws:

1 Remove the battery pack from this unit, then install the same battery pack again.

2 If the ERROR lamp flashes again: Install another battery pack.

3 If the ERROR lamp flashes again: The problem is with this unit.

Please contact your Authorized TOSHIBA TEC representative in connection with the product with the

problem.

Battery pack Charging time

B-415-BT about 4 hours

• Charging time

5. ATTACHING THE SHOULDER STRAP

5. ATTACHING THE SHOULDER STRAP

Attach the provided shoulder strap to the shoulder strap holders as Fig.5-1 shows.

Fig. 5-1

E5-1

5. ATTACHING THE SHOULDER STRAP

Contents

Main FCC Notice CAUTION To avoid injury, be careful not to catch or jam your fingers while opening or closing the cover. CAUTION CE Compliance (for EU only) Page Page Safety Summary Safety Precautions WARNING CAUTION Precautions CAUTION: TABLE OF CONTENTS 1. INTRODUCTION 1.1 Applicable Model NOTE: The B-415-GH34-GB model is for exclusive use in Great Britain. 1.2 Accessories 2. SPECIFICATIONS 2.1 Printer 2.2 IrDA Interface * Data Matrix 2.3 Serial Interface (RS-232C) (for GH24 and GH34 models) 2.5 Bluetooth Interface (for GH25 model) 2.4 Radio Interface (for GH34 model) The following specification is applicable only to the GB and QP models. 2.7 Battery 2.6 External DC Input 2.8 Option 2.9 Media NOTE: Do not use media other than the above to ensure print quality and print head life. 3. APPEARANCE 3.1 Front/Rear View 3.2 Description of LED Lamp 3.3 Description of Switch/Button 4. LOADING AND REMOVING THE BATTERY Battery Performance TO CHARGE THE BATTERY PACK Using the battery pack at once Charging time If the ERROR lamp flashes 5. ATTACHING THE SHOULDER STRAP 6. SET UP PROCEDURE 6.1 Requirements for Operation 7. LOADING THE LABEL 1 2 3 7.1 How to Load the Liner Backed Label Roll Page 7.2 How to Load the Linerless Label Roll Page 8. ISSUING THE MEDIA 4. Tear off the printed media upward or downward with the cutter. Media Fig. 8-2 9. SELF-DIAGNOSTIC TEST PRINT 9. SELF-DIAGNOSTIC TEST PRINT For GH25 model E9-1 Page 10. CARE/HANDLING OF THE MEDIA 11.1 Cleaning 11. GENERAL MAINTENANCE 11.2 Covers and Operation Panel 11.3 Removing Jammed Media 12. LED DISPLAY AND TROUBLESHOOTING NOTE: Please contact your authorized TOSHIBA TEC representative. 13. ERROR PROCESS