Toshiba B-415 - page 19

E7-2

7. LOADING THE LABEL ENGLISH VERSION EO1-33014

5. Load the liner backed label roll as Fig.7-3 shows.

6. Slide the paper guide (R) to accommodate the label roll width, and then push the release lever

downward to fix the paper guide (R).

NOTE: Before fixing the paper guide (R), make sure that the label roll rotates smoothly without

moving from side to side.

7.1 How to Load the Liner Backed Label Roll

Fig. 7-3

7. When printing in strip issue mode, draw out the top of the label roll onto the platen. When printing

in continuous or batch issue mode, insert the top of the label roll into the outlet of the media cover.

NOTE: Batch issue can be performed without the strip module. For removing the strip module, refer

to section 7.2 How to load the linerless label roll.

Strip Issue Batch Issue

Fig. 7-4 Fig. 7-5

Label Roll

Paper Guide (R)

Release Lever

Strip Module

Contents

Main FCC Notice CAUTION To avoid injury, be careful not to catch or jam your fingers while opening or closing the cover. CAUTION CE Compliance (for EU only) Page Page Safety Summary Safety Precautions WARNING CAUTION Precautions CAUTION: TABLE OF CONTENTS 1. INTRODUCTION 1.1 Applicable Model NOTE: The B-415-GH34-GB model is for exclusive use in Great Britain. 1.2 Accessories 2. SPECIFICATIONS 2.1 Printer 2.2 IrDA Interface * Data Matrix 2.3 Serial Interface (RS-232C) (for GH24 and GH34 models) 2.5 Bluetooth Interface (for GH25 model) 2.4 Radio Interface (for GH34 model) The following specification is applicable only to the GB and QP models. 2.7 Battery 2.6 External DC Input 2.8 Option 2.9 Media NOTE: Do not use media other than the above to ensure print quality and print head life. 3. APPEARANCE 3.1 Front/Rear View 3.2 Description of LED Lamp 3.3 Description of Switch/Button 4. LOADING AND REMOVING THE BATTERY Battery Performance TO CHARGE THE BATTERY PACK Using the battery pack at once Charging time If the ERROR lamp flashes 5. ATTACHING THE SHOULDER STRAP 6. SET UP PROCEDURE 6.1 Requirements for Operation 7. LOADING THE LABEL 1 2 3 7.1 How to Load the Liner Backed Label Roll Page 7.2 How to Load the Linerless Label Roll Page 8. ISSUING THE MEDIA 4. Tear off the printed media upward or downward with the cutter. Media Fig. 8-2 9. SELF-DIAGNOSTIC TEST PRINT 9. SELF-DIAGNOSTIC TEST PRINT For GH25 model E9-1 Page 10. CARE/HANDLING OF THE MEDIA 11.1 Cleaning 11. GENERAL MAINTENANCE 11.2 Covers and Operation Panel 11.3 Removing Jammed Media 12. LED DISPLAY AND TROUBLESHOOTING NOTE: Please contact your authorized TOSHIBA TEC representative. 13. ERROR PROCESS