Toshiba B-415 7. LOADING THE LABEL

E7-1

7. LOADING THE LABEL ENGLISH VERSION EO1-33014

7. LOADING THE LABEL

7.1 How to Load the Liner Backed Label Roll

1

2

3

Media Cover

Release Catch

Media Cover Release Catch

Strip Cover

Fig. 7-1

4. Fully raise up the release lever, and then slide the paper guide (R) to the right.

Fig. 7-2

Release Lever Paper Guide (R)

NOTES:

1. In the strip issue mode, you should use the printer with the side in which the model name

sticker is attached downward because the backing paper is issued from the bottom of the

printer.

2. In the strip issue mode, you can tear off the backing paper using the edge of the strip cover.

3. In the batch issue mode, you can tear off the backing paper at the perforation.

7.1 How to Load the Liner Backed Label Roll

1. Place the printer on a level surface as shown below.

2. To unlock the media cover, press the two cover release catches in the direction of the arrows.

3. Open the media cover by pushing up the strip cover.

Contents

Main FCC Notice CAUTION To avoid injury, be careful not to catch or jam your fingers while opening or closing the cover. CAUTION CE Compliance (for EU only) Page Page Safety Summary Safety Precautions WARNING CAUTION Precautions CAUTION: TABLE OF CONTENTS 1. INTRODUCTION 1.1 Applicable Model NOTE: The B-415-GH34-GB model is for exclusive use in Great Britain. 1.2 Accessories 2. SPECIFICATIONS 2.1 Printer 2.2 IrDA Interface * Data Matrix 2.3 Serial Interface (RS-232C) (for GH24 and GH34 models) 2.5 Bluetooth Interface (for GH25 model) 2.4 Radio Interface (for GH34 model) The following specification is applicable only to the GB and QP models. 2.7 Battery 2.6 External DC Input 2.8 Option 2.9 Media NOTE: Do not use media other than the above to ensure print quality and print head life. 3. APPEARANCE 3.1 Front/Rear View 3.2 Description of LED Lamp 3.3 Description of Switch/Button 4. LOADING AND REMOVING THE BATTERY Battery Performance TO CHARGE THE BATTERY PACK Using the battery pack at once Charging time If the ERROR lamp flashes 5. ATTACHING THE SHOULDER STRAP 6. SET UP PROCEDURE 6.1 Requirements for Operation 7. LOADING THE LABEL 1 2 3 7.1 How to Load the Liner Backed Label Roll Page 7.2 How to Load the Linerless Label Roll Page 8. ISSUING THE MEDIA 4. Tear off the printed media upward or downward with the cutter. Media Fig. 8-2 9. SELF-DIAGNOSTIC TEST PRINT 9. SELF-DIAGNOSTIC TEST PRINT For GH25 model E9-1 Page 10. CARE/HANDLING OF THE MEDIA 11.1 Cleaning 11. GENERAL MAINTENANCE 11.2 Covers and Operation Panel 11.3 Removing Jammed Media 12. LED DISPLAY AND TROUBLESHOOTING NOTE: Please contact your authorized TOSHIBA TEC representative. 13. ERROR PROCESS