8. LOADING THE PAPER

EO1-330019

8. LOADING THE PAPER

Setting the feed gap sensor position

1Move sensor knob A in a horizontal direction so that the mark on the sensor cover aligns with the centre of the label gap. Remember the number that the centre of the sensor knob A is positioned at. Set sensor knob B to the same position number.

The centtre of the gap

1 2 3 4 5

Sensor Cover

Feed Gap Sensor Position

Sensor Knob A

Fig. 8-14

2Release the lock lever in the direction indicated by the arrow, and gently lift the sensor cover. NOTE: Lift the sensor cover gently so that it does not touch the ribbon.

3Set the sensor knob B to the same position # of the sensor knob A.

NOTE: Sensor knobs A and B are set to position #3 where the black mark is centred on the label width as a default. Do not change the position of sensor knobs A and B except when changing the sensor detecting position. Be sure to set the sensor knobs A and B to the same position #. Failure to do this may cause a paper feed error and paper end detecting error.

4Draw the label onto the platen. Close the sensor cover and return the lock lever to lock the sensor cover tight.

8-6

Page 21
Image 21
Toshiba B-450-HS-QQ owner manual Setting the feed gap sensor position