8. LOADING THE PAPER
8. LOADING THE PAPER
■Setting the black mark sensor position
1Fold over the end of the label. Then, move sensor knob A in a the horizontal direction so that the 
mark on the sensor cover aligns with the black mark. Remember the number that centre of the sensor knob A is positioned at. Set the sensor knob B to the same position number.
Black Mark
1 2 3 4 5
Sensor knob A
Black Mark Sensor Position | Fig. |
Sensor Cover |
|
2Release the lock lever in the direction indicated by the arrow, and gently lift the sensor cover. NOTE: Lift the sensor cover gently so that it does not touch the ribbon.
3Set sensor knob B to the same position number as the sensor knob A.
NOTE: The sensor knobs A and B are set to the position #3 where the black mark is centred in the label width as a default. Do not change the position of sensor knobs A and B except when changing the sensor detecting position. Be sure to set sensor knobs A and B to the same position #. Failure to do this may cause a paper feed error and paper end detecting error.
Sensor Knob B
1 2 3 4 5
Fig.
4Draw the label onto the platen. Close the sensor cover and return the lock lever to lock the sensor cover tight.
