Toshiba B-450-HS-QQ SET UP Procedure, Requirements for Operation, Setting UP the Printer

5. SET UP PROCEDURE

EO1-33019

5.1 REQUIREMENTS FOR OPERATION

5. SET UP PROCEDURE

5.1 REQUIREMENTS FOR OPERATION

This machine has the following requirements:

∙The host computer must have a serial port or centronics parallel port.

∙To communicate with host, either an RS-232C cable or Centronics cable is required.

(1)RS-232C cable .......... 9 pins

(2)Centronics cable ....... 36 pins

∙To print a label format, create the complete program using the interface/communication manual or use a bespoke labelling package or Windows Driver.

■Interface Cables

To prevent radiation and reception of electrical noise, the interface cables must meet the following requirements:

∙Fully shielded and fitted with metal or metalised connector housings.

∙Kept as short as possible.

∙Should not be bundled tightly with power cords.

∙Should not be tied to power line conduits.

■RS-232C Cable description

The serial data cable used to connect the printer to the host computer should be one of the following two types:

NOTE: Use an RS-232C cable with imperial (inch) connector securing screws.

DB-9S		DB-9P
Connector to PC		Connector to Printer
PIN No.	Signal	PIN No.	Signal
1	N.C.	1	N.C.
2	RXD	2	TXD
3	TXD	3	RXD
4	DTR	4	DSR
5	GND	5	GND
6	DSR	6	DTR
7	RTS	7	CTS
8	CTS	8	RTS
9	N.C.	9	N.C.
Housing	Shield	Housing	Shield

DB-25S

Connector to PC

PIN No. Signal

1Shield

2TXD

3RXD

4RTS

5CTS

6DSR

7GND

20 DTR

DB-9P

Connector to Printer

PIN No. Signal

1N.C.

2TXD

3	RXD
4	DSR
5	GND
6	DTR
7	CTS

8RTS

9N.C.

Fig. 5-1

5.2 SETTING UP THE PRINTER

∙Place the printer on a flat, stable surface.

∙Use a grounded electrical outlet do not use adapter plug.

∙Be sure there is adequate room around the printer for easy operation and maintenance.

∙Keep your work environment static free.

5-1