2. MAJOR UNIT REPLACEMENT
2.8 REPLACING THE MEDIA SENSOR
NOTES: 1. When reassembling the sensor case cap, fit the hooks of the sensor case into portion A of the sensor case cap.
2.When reassembling the sensors, align the pins on the sensor case with the holes of the sensors.
3.Connect the harness including the green wire to the black mark sensor (lower side).
4.Pass the media sensor harness between the harness guides.
Front side of the printer
Black Mark Sensor |
| Sensor Case | |
(Lower side) | Green | ||
|
Pin
| Sensor Guide |
Feed Gap Sensor (LED) | Media Sensor Harness |
(Number of pins: 2) |
|
5. Since connectors of the sensors are small, be careful not to break their pins.
