Toshiba B-852-R manual Replacement

3. PERIODIC MAINTENANCE PROCEDURE EO18-33018

3. PERIODIC MAINTENANCE PROCEDURE

5.Apply FLOIL G-488 to the cutter unit using a soft cloth.

6.Clean the Cutter Blade with a cotton swab moistened with absolute ethyl alcohol.

Cutter Blade

Cutter Unit

7.Confirm that the problem occurs as reported, and then take corrective action.

8.Replace the following parts periodically, if necessary. The following table shows approximate product life for each part.

No.	Part Name	Part No.	Standard interval of
			replacement
1	Cutter unit (Option)	G0-00415000	1,000,000 cuts
2	Platen	FMCC0054701	50 km

NOTES: 1. The above values of the cutter life are obtained on condition that the periodically maintained cutter is used with TOSHIBA TEC-approved supplies by the proper method described in the manuals.

2.The above values differ depending on the thickness and substances of the media to be used. When using the cutter to cut the labels, be sure to cut the backing paper. Failure to do this may cause the glue to stick to the cutter and shorten the cutter life.

8.Confirm each part adjustment. Make any necessary adjustments.

9.Conduct the following tests and make sure that there is no problem.

1)Print test with TOSHIBA TEC-approved media and ribbon. (Print tone, print head position, etc.)

2)Paper skew

3)Print start position adjustment (Horizontal: media position, vertical: sensor adjustment/adjustment by issuing commands.)

4)Communication test

5)Abnormal noise

6)Confirm that there are not any other errors.

10.Close the top cover.

3-3