4. PARAMETER SETTING FUNCTIONS |
4. DIP SWITCH FUNCTIONS
4. PARAMETER SETTING FUNCTIONS
The Following table illustrates settings that are selected only by changing the Printer's PARAMETER settings. This procedure can be found in the Maintenance Manual section of the
■Parameter Setting Mode Table
Mode Name |
| Function |
SPEED | Baud rate of the serial interface is selected. | |
DATA LENG. | Data length of the serial interface is selected. | |
STOP BIT | Stop bit of the serial interface is selected. | |
PARITY | Parity of the serial interface is selected. | |
XON+READY | Transmission control mode of the serial interface is selected. | |
LCD | Language which displays LCD message is selected. | |
|
| |
FORWARD WAIT | Auto forward wait in cut mode is selected. When idle for 3 seconds or | |
| more after cutting, the printer automatically feeds the paper 10mm | |
| forward. |
|
|
| |
HEAD UP CUT | Print head up in cut mode is selected. If a back feed is performed when | |
| this parameter is ON, it is done while the print head is up. (Available | |
| only when the ribbon saving module is installed and the ribbon save | |
| mode is ON.) |
|
|
| |
RIBBON SAVE | The ribbon saving module is selected. Be sure to set this parameter to | |
| ON when using the ribbon saving module. | |
|
| |
CODE | The command code out of AUTO, ESC/LF/NUL, or { I } is selected. | |
RIBBON | Ribbon type either transmissive or | |
|
| |
SENS POSI | The media sensor position is selected. | |
| CENTER: Fixed | |
| EDGE: | Movable |
|
|
|