8. LOADING THE MEDIA
8. LOADING THE MEDIA
5.Turn the Lock Levers of the Media Holders to the unlock position and readjust the Media position to the center. Then lock the Media Holders securely with the Lock Levers. Fit the Media Guides to the Media. Tighten the screw A firmly.
Media Guide | Lock Lever | Media Holder |
|
|
Media
Media Holder
Media Guide | Screw A | Holder Stand |
| ||
|
| Notch |
| Holder Shaft | Bush |
Fig.
NOTE: Set in the bushes of the Holder Shaft into notches of the Holder Stand securely.
6.The black mark/feed gap sensor is selectable between the fixed type and the movable type by changing the printer's PARAMETER settings. Please contact your authorized TOSHIBA TEC representative to change the Operation Panel setting. When the fixed type is selected, the blackmark sensor is located at the center of the media and the feed gap sensor is at 10 mm left to the blackmark sensor. The movable sensor can be located anywhere between the left end of the effective print width and the fixed sensor.
After changing the sensor type, the sensitivity of the sensor must be adjusted. In this case call a TOSHIBA TEC authorized service representative.