Manuals / Toshiba / Computer Equipment / Printer

Toshiba B-880-QQ SERIES owner manual Installation Procedure, Connecting The Power Cord And Cables

Models: B-880-QQ SERIES

1 34

Download 34 pages 42.69 Kb

Page 13

6. INSTALLATION PROCEDURE

6. INSTALLATION PROCEDURE		EO1-33017
		6.1 CONNECTING THE POWER CORD AND CABLES

6. INSTALLATION PROCEDURE

6.1 CONNECTING THE POWER CORD AND CABLES

WARNING!

Turn the POWER SWITCH to OFF before connecting the power cord or cables.

Power Cord

Serial I/F Cable (RS-232C)	Fig. 6-1

	Parallel I/F Cable	Expansion I/O Cable
	(Centronics)	Expansion I/O Cable
	(Centronics)

NOTE: Different cables cannot be used at the same time.

6.2 HOLDER STAND INSTALLATION

Fit the left and right side holders into the dowels of the holder base and fasten the side holders to the holder base with the thumbscrews.

Thumbscrew

Left Side Holder

Right Side Holder

Holder Base

Fig. 6-2

Dowel

6-1

Image 13

Toshiba B-880-QQ SERIES Installation Procedure, Connecting The Power Cord And Cables, Holder Stand Installation

Contents

Owner’s Manual B-880-QQ SERIESTEC Thermal Printer for USA only Meanings of Each Symbol Safety SummarySafety Summary Request Regarding Maintenance PrecautionsSafety Summary TABLE OF CONTENTS 1. INTRODUCTION 1.2 ACCESSORIES1.1 APPLICABLE MODEL B - 8 8 2 - T S 1 0 - Q Q2.1 PRINTER 2. SPECIFICATIONSAuto Ribbon Saving Mode 2.2 OPTION2.4 RIBBON MEDIA2. SPECIFICATIONS 3.1 FRONT/REAR VIEW 3. OVERVIEW3.2 OPERATION PANEL POWER LED GreenParameter Setting Mode Table 4. PARAMETER SETTING FUNCTIONS4. PARAMETER SETTING FUNCTIONS The media sensor position is selected5.2 SETTING UP THE PRINTER 5. SET UP PROCEDURE5.1 REQUIREMENTS FOR OPERATION 6.1 CONNECTING THE POWER CORD AND CABLES 6. INSTALLATION PROCEDURE6.2 HOLDER STAND INSTALLATION 6. INSTALLATION PROCEDUREHead Lever Position 7. LOADING THE RIBBON8. Set the head lock plate 8. LOADING THE MEDIA 8. LOADING THE MEDIA5. Turn the Lock Levers of the Media Holders to the unlock position and readjust the Media position to the center. Then lock the Media Holders securely with the Lock Levers. Fit the Media Guides to the Media. Tighten the screw A firmly Feed Gap Sensor Black Mark Sensor Adjusting Knob Black Mark Media Setting the feed gap sensor positionBlack Mark Sensor Feed Gap Sensor Adjusting Knob Media An easy way to set the black mark sensor position8. The media is now loaded and the sensor position is set. Batch type Media Backing Paper Backing Paper Release Bar Backing Paper Holder 1. Turn the power off 9. INSERTING THE OPTIONAL PCMCIA CARD3. Turn the power on 10. CARE/HANDLING OF THE MEDIA AND RIBBON 10. CARE/HANDLING OF THE MEDIA AND RIBBON11.1 CLEANING 11. GENERAL MAINTENANCE7. Turn the pinch roller lever to the right 11.3 COVERS AND PANELS 11.2 UNDER THE MEDIA GUIDES11.4 REMOVING JAMMED MEDIA Cleaning the strip unit Cleaning the Cutter UnitThreshold setting procedure 11.5 THRESHOLD SETTING11. GENERAL MAINTENANCE Error Message 12. TROUBLESHOOTINGProblem SolutionProblem Error MessageSolution Problem Error MessageSolution ProblemPage Page PRINTED IN JAPAN EO1-33017