27
After system check completion, the Standby key changes from flashing to steady ON, allowing camera images
to be displayed.
Note
When the Recorder is used for the first time or when the power was switched off for a long period of time, the
date and time could not be correctly displayed. Perform the clock setting before use. (Refer to p. 14; "Clock
Settings.")
8. DIGITAL VIDEO RECORDER ACTIVATION AND TERMINATION

8.1. Recorder's Activation

The switch and key shown in the following figures are used in operation.
1. Connect each component correctly. (Refer to p. 40; "Connections.")
2. Set the rear-panel mounted Main Power switch to the ON position.
The Standby key flashes green for 5 seconds while settings are initialized. Thereafter, the Recorder is
placed in standby mode. The Standby key flashes every 5 seconds while in standby mode.
Note
Do not turn off the Main Power switch while the Standby key is flashing. Ensure that the Recorder is in the
standby mode when turning off the Main Power switch.
Logged data could be damaged or lost if the main power is switched off during initialization (while accessing
the hard disk).
3. Press the Standby key while the Recorder is in standby mode.
The screen automatically changes as shown below.
The Standby key flashes green during a system check.
AC MAINS MAIN POWER
ON
OFF
IN OUT IN OUT
VIDEO SW VIDEO IN
OUT
AUDIO
GND GND
100BASE–TX
ALARM RESET OUT
ALARM IN
SW CTRL OUT
TIME SYNC IN
REC STOP IN
REC START IN
ALARM RESET IN
TIME SYNC OUT
ALARM OUT
FAILURE OUT
DISK FULL OUT
RS–232C
Main Power Switch
DIGITAL VIDEO RECORDER
DISK FULL/
FAILURE
ALARM
RESET
BUZZER
STOP
SEARCH
MENU
SELECT
BLOCK
PLAY
STOP
PLAY
PAUSE
REVERSE
PLAY
REC
TIMER
FRAME FRAME
OUTPUT
VIDEO AUDIO
Standby Key
SYSTEM CHECK COMPLETED
V e r .
SYSTEM CHECK IN PROGRESS
PLEASE WAIT