CLOCK SETTING
THU JAN / 01 / 04 00:00:00
TIME SETTING : SELECT KEY
TIME SYNC [ SLAVE]
SYNC TIME [00H]
SUMMER TIME SETTING
<CURRENT TIME>
THU JAN / 01 / 04 00:00:00
14
7.3. Clock Settings
Set the date and time. Perform this setting when the Recorder is used for the first time or when the date and
time indication has been deleted because the power was switched off for a long period of time.
Note
• Previously logged data times are not updated even if the Clock Settings are changed during use.
• The data times will be lost if the power was switched off for 30 days or more. Set the date and time again.
Memory backup: 720 hours (fully charged)
TIME SYNC : Synchronizes the times of other Recorders (slave units) with that of a specified Recorder
(master unit) when multiple Recorders are used.
SYNC TIME : Sets the synchronization time.
Note
The Time Sync function cannot be operated during recording.
• Move the cursor with the ( ) or ( ) key, and change setting values
with the (–) or (+) key.
• After completing the settings of time (hour, minute, second), confirm
the time with the Select key.
• The indication "Clock Setting Completed" is displayed on the screen
after setting completion.
• Current time is displayed in the lowest part of the screen.
• Confirm the setting with the Menu key, and return to the previous
screen.
• Each setting item and its setting value and contents are as shown in
the table below.
Setting Value Contents
Setting Item
TIME SYNC
(Time
Synchronization)
SYNC TIME (Synch-
ronization Time)
MASTER: Designates the master unit.
SLAVE: Designates the slave unit.
Select and set the synchronization time.
MASTER / SLAVE
00H/ 01H / 02H / 03H / 04H / ...
up to 23H
* The underlined contents are factory-preset values.
Note
Setting the Time Sync settings to "SLAVE," and the Disk Setting’s Disk Mode to "SERIES" places the
Recorder in Disk Full mode, causing the Disk Full indicator to light. Perform this setting when using Series
Recording. Refer to p. 41; Expansion System (Series Recording).