Toshiba CS8560D specifications External sync spec, Shutter trigger spec, Sync signal spec

[External sync spec]
(1)	Ext. sync input signal	HD/VD
(2)	Input impedance	75-ohm / High impedance 10k-ohm (switching via rear-panel SW)
		(Initial factory setting: High)
(3)	Input level	From 2 through 5V (p-p) under high impedance input
		From 2 through 4V (p-p) under 75-ohm input
(4)	Interlace	1/60s non-interlace or 1/120s 2:1 interlace
(5)	Polarity	Negative
(6)	Pulse width	HD: 3.2 +/- 1 micro s (LOW)
		VD: From 125 through 400 micro s (LOW)
(7)	Repeating frequency	fH = 31.468kHz +/- 1%
		fV = fH/262.5 or fH/525
(8)	Phase difference	HD/VD: 0 +/- 5.0 micro s, 1/fH/2 +/- 5.0 micro s
[Shutter trigger spec]		Exposure-starting-cue signal in random trigger shutter mode
(1)	Input level	LOW level: From 0 through 0.5V(p-p)
		HIGH level: From 4 through 5V(p-p)
(2)	Input impedance	High impedance (10k-ohm)
(3)	Capture timing	Rising edge detection (Positive)
		(Falling edge detection (Negative) as [Option])
(4)	Pulse width	Minimum 2 micro s
		Maximum 1/8s
[Sync signal spec]
(1)	Readout signal	WEN readout timing pulse
(2)	Polarity	Negative (Positive under VIDEO output mode [Option])
(3)	Pulse width	1H output (Available under VIDEO output mode [Option])

VIDEO OUT
WEN OUT
（1H）	NEGA
WEN OUT
(VIDEO output)	POSI
[Option]

(4)Output circuit * Set WEN termination to be high impedance.

5V

WEN

100

WEN OUT

50

Note: Items shown as [Option] in this document is not included in your purchase as standard components. Contact our dealer / distributor for details.

25 D4130891A