Toshiba TRST-56 SERIES, EO1-13016 owner manual SET UP Procedure

4. SET UP PROCEDURE

EO1-13016

4.1 Requirements for Operation

4. SET UP PROCEDURE

4.1 Requirements for Operation

This printer has the following requirements:

Serial interface Type

∙The TOSHIBA TEC POS terminal to be connected must have a serial port.

∙To communicate with the TOSHIBA TEC POS terminal, an RS-232C interface cable is required. RS-232C cable........ 25 pins

Parallel Interface Type

∙The TOSHIBA TEC POS terminal to be connected must have a Centronics parallel port.

∙To communicate with the TOSHIBA TEC POS terminal, a Centronics interface cable is required. Centronics cable ..... 36 pins

Interface Cables

For the serial interface model, use the CBLST-50-2-QM serial printer cable available from TOSHIBA TEC or equivalent. For the parallel interface model, use the Centronics cable which satisfies the following pin configuration and the specification of the connector.

To prevent the emission and receipt of electrical noise, the interface cable must meet the following requirements:

∙Fully shielded and fitted with metal or metalized connector housings.

∙Kept as short as possible.

∙Should not be tightly bundled with the power cord.

∙Should not be tied to power line conduits.

RS-232C cable pin configuration

POS terminal side D-SUB 9-pin female

PIN No.	Signal
Case	FG
2	RXD
3	TXD
8	CTS
4	DTR
5	GND
6	DSR

Printer side D-SUB 25-pin male

PIN No.	Signal
1	FG
2	TXD
3	RXD
4	RTS
6	DSR
7	GND
20	DTR

Centronics cable pin configuration

POS terminal side D-SUB 25-pin male

PIN No.	Signal
1	/STROBE
2-9	PD1-8
10	/ACK
11	BUSY
12	PERROR
13	SELECT
14	/AUTOFD
16	/INIT
15	/FAULT
17	/SELECTIN
18-25	GND

Printer side

IEEE1284-B receptacle

PIN No.	Signal
1	/STROBE
2-9	PD1-8
10	/ACK
11	BUSY
12	PERROR
13	SELECT
14	/AUTOFD
31	/INIT
32	/FAULT
36	/SELECTIN
19-30	GND
15-18	N.C.
33-35	N.C.

NOTE: For details of the interface cable, contact your nearest TOSHIBA TEC representative.

4- 1