4 USING ADDRESS BOOK
92 Managing Address BookSending Options tab
In the Sending Options tab, the following items are displayed:
When displaying the properties of a contact in the private address book, you can modify the fol-
lowing settings:
- Use Sub Address and sender information
- Sub Address
- Sender Identification
Items other than the above cannot be set.
yUse Device Settings — This is checked when the contact is set to use the device settings
rather than using the settings on this tab.
yUse Sub Address and sender information — This is checked when the sub address trans-
mission for this contact is enabled. When this is checked, a document will be always sent
using the specified sub address and SID. Also you can use this contact to perform polling
transmission from the mailbox in the remote facsimile using the specified sub address and
password.
ySub Address — Display the sub address or mailbox number of remote facsimile where a
document will be sent.
ySender Identification — Display the security password for the sub address if required.
ySelective Polling — Display the mailbox number of remote facsimile where a document will
be retrieved.
yPassword — Display the password for the selective polling if required.
yOverseas Calls — This is checked when calling the contact fax number will be oversea call.
yError Correction Mode — This is checked when the ECM for this contact is enabled.
yPrint Transmission Report — This is checked when printing the transmission report after
the transmission is enabled.
yReduction — This is checked when the attenuation is enabled.
yShort Protocol — This is checked when the short protocol is enabled.
yLine Monitor — This is checked when the Line Monitor for the fax transmission is enabled.
yLine Selection — Display whether the line 1 or line 2 is used for the fax transmission. The
line 2 can be selected only when optional Line 2 board is installed.
yTransmission Type — Display whether the memory transmission or direct transmission is
used for the transmission.