1)Discard printing
-Since the trailing edge area of the original is normally blank, this blank area is cut off to allow the image fit in one sheet in this mode. Image reduction is not performed.
-Maximum discarding amount:
0 mm: Discard not performed
10 mm: Corresponding to the inside the TTI
18 mm: Corresponding to the outside the TTI 1
22 mm: Corresponding to the outside the TTI 2
34 mm: A4 → LT conversion
(TTI: Transmission Terminal Identifier)
When the discard function is ON
Actual size recording is performed with no vertical reduction nor division. The original image is recorded as it is. Namely, the data exceeding the effective printing area are discarded.
A | A |
B | A : Effective printing length |
| |
| B : Recording data length outside the |
Area B is discarded. | effective printing area |
| (A + B = Recording data length) |
Discard parameter
The following parameters are available:
Discard function | Length of B (Discard parameter) | Set value |
|
|
|
OFF | 0 mm | 0 |
|
|
|
ON | 10 mm | 1 |
|
|
|
| 18 mm | 2 |
|
|
|
| 22 mm | 3 |
|
|
|
| 34 mm | 4 |
|
|
|
Reference: These parameters should be set by the service technician (in the FAX Function Mode).
2)Vertical reduction printing
-The recording data length is reduced so that the image fits in the recording paper.
The data can be reduced up to 90/75%, and the machine automatically selects the appropriate ratio.
3)Regular size reduction printing
-When the discard and vertical reduction printing cannot be applied to the received image, and any of the combinations A3 → B4, A3 → A4, B4 → A4, B4 → B5, B4 → A5, A4 → B5, A4 → A5, COMP → LT, COMP → ST, LD → COMP, LD → LG/LT, LD → ST, LT → ST, FOLIO → B5, FOLIO → A5 is satisfied, the regular size reduction printing is performed.
In case that the recording data length is within the effective printing length A, but the recording paper of the same size as the original’s or larger size is not available;
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved | |
|
2 - 4
