10
Hardware Reset Occasionally resetting the system can return the camera to normal operation. If the system
problems remain after resetting, restore the factory settings and install again.
The IK-WP41A has a reset terminal and default terminal. (See QSG on page 17)
Reset:
Using a pointed object, short both terminals of “Reset”. Wait for the Network Camera
to reboot.
Restore: Using a pointed object, short both terminals of “Default” for about 5 seconds to
restart the camera. Note that all settings will be restored to factory default.
NOTE
Restoring the factory defaults will erase any previous settings such as IP address, ID and
Password.
This network camera is compliant with Micro SD/SDHC 32GB and other preceding
standard
Micro SD cards for local storage.
● There is a limit to the number of rewrites that is possible with the SD memory card.
Replacing
the SD memory card when performing periodic maintenance of the camera is
recommended.
● Do not use 512MB and below SD memory cards.
● The Camera system reserves approximately 100MB in SD memory cards. Any
images are not recordable on this space.
● Carefully read the User’s guide, precautions on use, and any other information
supplied with a purchased memory card.
● An SD memory card can be used for repeated storage. The lifespan (number of
rewrites possible) of an SD memory card is greatly affected by the capacity of the SD
memory card.
● Do not use a memory card containing the data recorded by another device with the
camera as this may result in the camera not functioning correctly.
● Do not modify, overwrite the data, or change the folder name of an SD memory
card. It may result in the camera not to function correctly.
● If you unmount or remove the SD memory card from camera, you have to turn OFF
the power of camera.