30
Multicast Address
Specify the multicast address (e.g. of the switch or router)
H264
Transfer Type
Select “Unicast” or “Multicast”. In “Multicast” mode camera
supports IGMP.
H264 RTSP
Port Number
Specify the port number you
would like to use for RTSP
protocol, from 1 to 65530,
default is 554.
Specify the port number you
would like to use for RTSP
protocol, from 1 to 65530,
default is 556.
H264 Video
Port Number
Specify the port number you
would like to use for video
streaming, from 1 to 65530,
default is 5000
Specify the port number you
would like to use for video
streaming, from 1 to 65530,
default is 5010
NOTE:
Since this camera uses a HD sensor, an Image not over 480P is displayed
vertically.
Max. Connections of real time:
Up to 3 simultaneous Unicast users at 1080P.
Up to 10 simultaneous Unicast users.
Alarm
There are 6 alarm input terminals and 1 output terminal on the base of the camera
and each alarm contain 32 preset actions, when alarm 1-6 is triggered, the camera
will immediately move to the preset position.
Alarm In1 to Alarm In6
Input Type: Set the alarm contact type as Normal Open or Normal Close. For
alarm input type, the active state is shown on the page 19 in the QSG.
Actions: Specify the action to be taken when alarm is triggered.
No action will be
taken (but an alarm is logged).