11
Installation Hardware Installation
Please verify that your product package contains all the accessories listed in the
Package Contents listed on page 7. Depending on the user’s application, an Ethernet
cable may be needed. The Ethernet cable should meet the specs of UTP Category 5e
or higher.
Hardware Installation is shown in the Quick Start Guide(QSG). Please refer to page
10 of the QSG.
Network Deployment
In this user’s manual, “User” refers to whoever has access to the Network Camera,
and “Administrator” refers to the person who can configure the Network Camera and
grant user access to the camera.
Network Deployment is shown in the Quick Start Guide(QSG). Please refer to page
19 of the QSG.
Micro SD/SDHC Card Installation
NOTE:
Card slot is in the inside of a camera. You should turn off all power before
installation.
When installing the SD/SDHC card, be careful not to generate static electricity at
the time.
When installing the SD/SDHC card, don’t touch the internal wiring.
Check if the silica-gel also needs to be exchanged.
Refer to 10 pages of QSG for details.
1. The dome cover and the internal black cover are removed.( Refer to 10 pages of
QSG.)
When you remove the internal black cover, remove the two screws indicated by
the arrows.