Block | Toshiba KD-1025 specification

(2)Take off the block from the side cover.

(3)Take off the side cover while pushing the front side of the side cover inward.

(4)Disconnect 1 connector.

KD-1025

DISASSEMBLY AND REPLACEMENT

Block

Fig. 4-9

Connector

Fig. 4-10

© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved

4 - 4

Image 22

Toshiba KD-1025 manual Block

Contents

KD-1025 Trademarks General Precautions for INSTALLATION/SERVICING/ Maintenance Page Contents Contents Specifications KD-1025 Specifications Overview Front Sectional View Layout of Electrical Parts CLT3 CLT1 M3 PWB Electrical Parts Motor Overview General Operation Driving System and Feeding Operation Ready status From power on to readyDescription of Operations From the start to the end of copying Call for Service Error DetectionJam detection Flow Chart Upper drawer feeding ON? General Operation Drawers Disassembly and ReplacementInstallation and Removal of Drawers and Covers Drawer cover Stabilizer cover Rear cover Feeding side rear cover Feeding side front coverSide cover Block PFP board PWB Upper/Lower Transport Rollers Upper transport roller Lower transport roller Remove the coupling, pin, and clip Bracket Motor Upper drawer tray-up motor Lower drawer tray-up motor Protrusion PFP motor assembly PFP motor Remove 1 connector and take off the PFP motor assembly Drawer feeding unit Feed/Separation/Pickup RollerSeparation roller Feed roller Pickup roller Drawer feed clutch CLT2/CLT3 Tray-up sensor S4/S5/paper empty sensor S6/S7 Switches and SensorsPaper stock sensor S10/S11 Side cover open/close switch S1 Upper/lower drawer feed sensor S2/S3 Upper/lower drawer detection switches S8/S9 Drawer detection switch Diagram5.1 Harness IRCUITC5. Electric Circuit Diagram Electric Circuit Equipment PC Board Electric Circuit Periodic Maintenance Symbols used in the checklist Apply grease On the inside entirely Lever Separation roller Ver.02 Revision RecordVer.01 Revision Record