Specifications | Toshiba KD-1025 specs

KD-1025	© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
SPECIFICATIONS

1 - 2

Image 8

Toshiba KD-1025 manual Specifications

Contents

KD-1025 Trademarks General Precautions for INSTALLATION/SERVICING/ Maintenance Page Contents Contents Specifications KD-1025 Specifications Overview Front Sectional View Layout of Electrical Parts CLT3 CLT1 M3 PWB Electrical Parts Motor Overview General Operation Driving System and Feeding Operation From power on to ready Description of OperationsReady status From the start to the end of copying Jam detection Error DetectionCall for Service Flow Chart Upper drawer feeding ON? General Operation Disassembly and Replacement Installation and Removal of Drawers and CoversDrawers Drawer cover Stabilizer cover Rear cover Side cover Feeding side front coverFeeding side rear cover Block PFP board PWB Upper/Lower Transport Rollers Upper transport roller Lower transport roller Remove the coupling, pin, and clip Bracket Motor Upper drawer tray-up motor Lower drawer tray-up motor Protrusion PFP motor assembly PFP motor Remove 1 connector and take off the PFP motor assembly Separation roller Feed/Separation/Pickup RollerDrawer feeding unit Feed roller Pickup roller Drawer feed clutch CLT2/CLT3 Paper stock sensor S10/S11 Switches and SensorsTray-up sensor S4/S5/paper empty sensor S6/S7 Side cover open/close switch S1 Upper/lower drawer feed sensor S2/S3 Upper/lower drawer detection switches S8/S9 Drawer detection switch Diagram5.1 Harness IRCUITC5. Electric Circuit Diagram Electric Circuit Equipment PC Board Electric Circuit Periodic Maintenance Symbols used in the checklist Apply grease On the inside entirely Lever Separation roller Ver.01 Revision RecordVer.02 Revision Record