PFP board PWB | Toshiba KD-1025 specs

4.2PFP board (PWB)

(1)Take off the rear cover. P.4-2 "[D] Rear cover"

(2)Disconnect 6 connectors, remove 2 screws, and release 2 locking supports to take off the PFP board.

Locking	Screws
supports
	PFP board
Fig. 4-11

4

© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved	KD-1025
	DISASSEMBLY AND REPLACEMENT

4 - 5

Image 23

Toshiba KD-1025 manual PFP board PWB

Contents

KD-1025 Trademarks General Precautions for INSTALLATION/SERVICING/ Maintenance Page Contents Contents KD-1025 Specifications Specifications Front Sectional View Overview CLT3 CLT1 M3 PWB Layout of Electrical Parts Motor Electrical Parts Overview Driving System and Feeding Operation General Operation From the start to the end of copying From power on to readyDescription of Operations Ready status Jam detection Error DetectionCall for Service Upper drawer feeding Flow Chart ON? General Operation Drawer cover Disassembly and ReplacementInstallation and Removal of Drawers and Covers Drawers Rear cover Stabilizer cover Side cover Feeding side front coverFeeding side rear cover Block PFP board PWB Upper transport roller Upper/Lower Transport Rollers Lower transport roller Remove the coupling, pin, and clip Bracket Upper drawer tray-up motor Motor Lower drawer tray-up motor Protrusion PFP motor PFP motor assembly Remove 1 connector and take off the PFP motor assembly Separation roller Feed/Separation/Pickup RollerDrawer feeding unit Pickup roller Feed roller Drawer feed clutch CLT2/CLT3 Paper stock sensor S10/S11 Switches and SensorsTray-up sensor S4/S5/paper empty sensor S6/S7 Upper/lower drawer feed sensor S2/S3 Side cover open/close switch S1 Drawer detection switch Upper/lower drawer detection switches S8/S9 IRCUITC5. Electric Diagram5.1 Harness Circuit Diagram Electric Circuit Equipment PC Board Electric Circuit Symbols used in the checklist Periodic Maintenance Apply grease On the inside entirely Lever Separation roller Ver.01 Revision RecordVer.02 Revision Record