Optional Devices
7.Push the module down so it lies flat. Latches on either side will click into place to secure the module.
Slot A
1
2 | Slot B |
|
Installing the memory module
8.Seat the cover and secure it with the screws.
9.Replace the battery pack as described in Chapter 6, Power and Power- Up Modes.
10.Turn the power on and make sure the added memory is recognized. Open System in the Control Panel and click the General tab.
Removing a memory module
To remove the memory module, make sure the computer is in boot mode then:
1.Be sure the power is off and all cables are disconnected from the computer.
2.Turn the computer upside down and remove the battery and the screws securing the memory module cover.
3.Slide your fingernail or a thin object under the cover and lift it off.
4.Lift one side of the insulator and push the latches to the outside to release the module. A spring will force one end of the module up.
5.Grasp the module by the sides and pull it out.
■If you use the computer for a long time, the memory modules will become hot. In this case, let the memory modules cool to room temperature before you replace them. Or you will get burnt if you touch any of them.
■Do not touch the connectors on the memory module or on the computer. Debris on the connectors may cause memory access problems.
User’s Manual |