4.17 VGA Board | 4 Replacement Procedures |
3.On the bottom side of the VGA board, remove three M2.5x3 screws from the VGA board heat sink, then disengage it.
Figure 4-33 Removing the VGA Board-2
NOTE: The VGA board screws must be removed in a specific order, as shown above, to prevent causing inadvertent damage to it.
Installing the VGA Board
To install the VGA board, follow the steps below and refer to the figures in the preceding section.
1.Connect the VGA board heat sink to the bottom of the VGA board.
NOTE: The VGA board screws must be tightened in a specific order, as shown above, to prevent causing inadvertent damage to it.
2.Attach the VGA board to the system board.
3.Secure it with one M2.5x3 screw.
Satellite M70/Satellite Pro M70 Series Maintenance Manual | [CONFIDENTIAL] |
