This remote control is compatible for most of Toshiba
The GUI of cube commander is also similar layout of the push buttons so that once the position of these key pads are getting familiar, both can be used without any difficulty.
Difference between this remote control and software is, the ID number access, this is caused by the command generation CPU, in a PC which the software is installed or use the CPU in the cube.
Power
ID mode
ID.ALL
ID.SEL
ID.SET
ID.CLR
Adjust
ßà normal mode ßà Power
Digital
Video1
RGB1
RGB2 White Balance
Adjust Call
STD
*MODE
adjust mode ßà special mode
Cut |
| 1: | |
Drive | 7: Picture in Picture | ||
Gain | 8, A, B, C: OSD color | ||
| 9: Power Delay time | ||
Contrast | D: Firmware Version | ||
Brightness | E: Lamp Timer History | ||
Color | F: Current Lamp timer | ||
Tint |
|
|
|
Sharpness |
|
|
|
Phase | ßà | service mode |
|
Clock |
| 0: |
|
Capture |
| 1: OSD Mute | |
*MODE button makes to recall Magnification memorized at
This chart is indicating the functions and also which button can be selected.
Magnification | 2: Screen mode Lock |
Layout | 4: Picture smoothing filter |
Position | C: |
Test pattern |
|
Mode |
|
Flip
Call
7: Color Mix (color coordinate) 4=R, 5=G, 6=B
ADJUSTMENT
3-1. Input Signal selection
Sources are selected by pressing the relevant source button: RGB1
RGB2 or VIDEO. To select and display video picture, the video input adaptor need to be installed.
The screen will mute for approximately
27
