PORTÉGÉ/TECRA R700 Series

4.Turn the computer upside down and remove the battery pack (refer to Replacing the battery pack section in chapter 6, Power and Power-Up Modes, if required).

5.Loosen the two screws securing the memory module cover in place - please note that the screws are attached to the cover in order to prevent them from being lost.

Use a point size 0 Phillips screwdriver.

6.Slide your fingernail or a thin object under the cover and lift it off.

Figure 3-8 Removing the memory module cover

1

2

1. Screws

2. Memory module cover

7.Align the notch of the memory module with that of the memory slot and gently insert the module into the slot at about a 30 degree angle before holding it down until the latches on either side snap into place.

User’s Manual

3-26