Other Function

Sleep Timer Setting

You can set the DVD/CD Receiver to turn off automati- cally at a specified time.

1Press SLEEP to set the desired sleep time.

The SLEEP indicator and sleep time appears in the dis- play window.

2Each time you press SLEEP the setting changes in the following order.

SLEEP 90 →80 → 70 → 60→ 50 → 40 → 30 → 20 →10 →

OFF

Note

You can check the time remaining before the DVD/CD receiver turns off.

Press SLEEP. The remaining time appears in the display window.

Dimmer

This function will change the brightness of the display window on the front panel during power-on status.

Press the DIMMER repeatedly.

Mute

Press MUTE to mute your unit.

You can mute your unit in order, for example, to answer the telephone, “MUTE” indicator flashes in the display window.

Using Headphone Jack

Connect a stereo headphone plug (3.5mm) into the PHONES connector.

The speakers are automatically disconnected when you plug in a headphone (not supplied).

Selecting input source

You can use VCRs or other units connected to the AV1, AV2 connectors, EURO SCART, Coaxial connector or Optical connector. Refer to the owner’s manual supplied with the unit for further information on the operation.

Press AUX repeatedly on the remote control to select the desired input source.

Each time you press this button, the mode of the func- tion changes in the following sequence:

AV 1: for selecting the analog signal from AV1 AUDIO IN (L/R) & VIDEO IN Connectors.

AV 1 OPT: for selecting the optical digital signal from AV1 VIDEO IN & OPTICAL IN Connector.

AV 1 COAX: for selecting the coaxial digital signal from AV1 VIDEO IN & COAXIAL IN Connector.

AV 2: for selecting the analog signal from AV2 AUDIO IN (L/R) & VIDEO IN Connectors.

AV 2 OPT: for selecting the optical digital signal from AV2 VIDEO IN & OPTICAL IN Connector.

AV 2 COAX: for selecting the coaxial digital signal from AV2 VIDEO IN & COAXIAL IN Connector.

TV-AUDIO:for selecting the TV audio signal from the TV that is connected by the SCART cable.

Notes

There is only one set of OPTICAL and COAXIAL input connectors. They are common for AV1 and AV2. The Optical input function is available only when the other unit’s Sampling Frequency is 32 ~ 96kHz.

You can also select the input source by pressing FUNC./PLAY button on the front panel.

Press and hold down this button about 3 seconds, then press repeatedly to select input source.

Reception of RDS (Radio Data System) Stations

RDS (Radio Data System) is a system gradually being introduced on FM in many countries, where by an inaudible stream of data is transmitted in addition to the normal radio signal. This data contains various informa- tion including station/ transmitter identification, traffic information and a list of alternative frequencies for the radio station being received.

1Press FM/AM to select FM.

2PRESET + or - .

When the RDS transmission is received, the display

shows the program service name (PS) after RDS indicator appears.Select a desired station by pressing the

3Press RDS to recall the frequency.