Operation with Radio

Presetting the radio stations

You can preset 50 stations for FM and AM (MW). Before tuning, make sure that you have turned down the vol- ume.

1

Press FM/AM on the remote control until FM or

AM (MW) appears in the display window.

2

And then every time you press FM/AM, FM and

AM (MW) changes alternately.

 

Press and hold TUNING - or + on the front panel

3 for about two seconds until the frequency

 

indication starts to change, then release.

 

Scanning stops when the DVD/CD Receiver tunes in a

 

station. “TUNED” and “STEREO” (for stereo program)

 

appear in the display window.

4

Press STOP/MEMO. on the front panel.

A preset number will flash in the display window.

5 Press TUNING - or + on the front panel to select the preset number you want.

Press STOP/MEMO. on the front panel again.

6 The station is stored.

7Repeat steps 3 to 6 to store other stations.

To tune in a station with a weak signal

Press TUNING - or + repeatedly in step 3 to tune in the station manually.

To clear all the stored stations

Press and hold STOP/MEMO. for about two seconds and “CLEAR ALL” is appeared in the display window and then press STOP/MEMO. again, the stations are cleared.

If you have accidentally entered into the "CLEAR ALL" mode and you do not wish to clear the memory, do not press any key. After a few seconds, the "CLEAR ALL" display will go off by itself and change to normal mode.

Note

If all stations have already been entered, the FULL message will appear in the display window for a moment and then a preset number will flash.

To change the preset number, follow the steps 5-6 as above.

Listening to the radio

Preset radio stations in the DVD/CD Receiver’s memory first (see “Presetting radio stations” on the left).

Press FM/AM until AM (MW) or FM appears in

1 the display window.

The last received station is tuned in.

Press PRESET + or - repeatedly on the remote

2 control to select the preset station you want.

Each time you press the button, the DVD/CD Receiver tunes in one preset station at a time.

3front panel or by pressing VOLUME + or - on the remote control repeatedly.Adjust the volume by rotating VOLUME on the

To turn off the radio

Press POWER to turn the DVD/CD receiver off or select another function mode (CD/DVD, AV1, etc.,).

To listen to non-preset radio stations

Use manual or automatic tuning in step 2.

For manual tuning, press TUNING - or + on the front panel repeatedly.

For automatic tuning, press and hold TUNING - or + for about two seconds on the front panel.

To select a preset radio station directly

You can use the number buttons on the remote control to select a preset radio station directly.

For example, to listen to preset station 4, press 4 on the remote control. To listen to preset station 19, press 1 then 9 (within 3 seconds).

For your reference

If an FM program is noisy

Press MONO/ST. on the front panel so that “STEREO” disappears in the display window. There will be no stereo effect, but the reception will improve. Press the button again to restore the stereo effect.

To improve reception

Reorient the supplied antennas.

28

Page 28
Image 28
Toshiba SD-44HKSE owner manual Operation with Radio Presetting the radio stations, Listening to the radio