Preparing and using the remote control
■Loading dry-cell batteries into the remote control
(1)Remove the battery cover.
(2)Insert the
Be sure to align the plus and minus ends of the batteries properly.
Two batteries (R03, size AAA) are used.
■Point the remote control toward the projector’s infrared remote sensor and
press a button.
• Operating the projector from the front
• Operating the projector from the rear
Preparations
(3) Put back the battery cover.
Dry-cell batteries
•Before using the batteries, be sure to observe the Safety Precautions described in previous pages.
•Remove batteries from remote control when not using for extended periods.
•If the remote control stops working, or if its range decreases, replace all the batteries with new ones.
The remote control
•The remote control may fail to operate if the infrared remote sensor is exposed to bright sunlight or fl uorescent lighting.
•Do not drop the remote control or strike it on a hard surface.
•Do not leave it in a hot or humid location.
•Do not get it wet or place it on top of wet objects.
•Do not take it apart.
•In rare cases, ambient conditions could impede the operation of the remote control. If this happens, point the remote control at the main unit and repeat the operation.
21