Connecting the power cord, Turning the power on | Toshiba TDP-MT200

English Français Español Deutsch Italiano Português Svenska

■Connecting the power cord

1Insert the power cord connector into the AC IN socket of the projector.

2Insert the power cord plug into a wall or other power outlet.

Power cord connector (Supplied)

■Removing the lens cover

Be sure to remove the lens cover when the power is turned on. If it is left on, it could become deformed due to heat.

Preparations

■ Turning the power on

1 Turn on the main power switch

The ON indicator will change to orange, indicating standby mode.

•After the main power switch is turned on, the inner cooling fan starts cooling.

(Orange)

2Press the ON/STANDBY button.

The power turns on, and the following 3 green indicators light: ON, LAMP, and FAN. After a moment, the start-up screen appears.

Remote	Start-up screen
Control panel Control

CAUTION

•Do not look into the lens while the lamp is on. The strong light from the lamp may cause damage to your eyes or sight.

•Do not block the air intake or exhaust. Doing so could cause a fire due to internal overheating.

•Do not place your hands, face, or other objects near the air exhaust. Doing so could cause burns, deform/break the object.

21

Image 21

Toshiba TDP-MT200 owner manual Connecting the power cord, Removing the lens cover, Turning the power on

Contents

TDP-MT200 USA only Safety Precautions Before Using Power Sources Important Safety InstructionsSource of Light Ventilation Cleaning Power-Cord ProtectionHeat Water and Moisture Important Safety Instructions Accessories Damage Requiring ServiceServicing Replacement Parts Safety CheckDo not use the product in a closed installation state Important Precautions Power Supply Cord SelectionPlace and Manner of Installation Save Original Packing Materials Exemption Clauses Important Precautions Avoid Volatile Liquid Other Cautions and Informations Remote Control Batteries Contents Others Checking the package contents 108 11 Names of each part on the main unit Names of each part on the control panel and remote control Parts on the rear panel Loading dry-cell batteries into the remote control Preparing and using the remote controlOperating the remote control Remove the battery cover Insert the dry-cell batteries Placement Styles PlacementProjection Distance and Size Screen As seen from above Before connection Connection Connecting the power cord Turning the power onRemoving the lens cover Turning the power off Turning the power on and offPress the ON/STANDBY button Press the ON/STANDBY button again Basic operations Turn on the powerActivate the connected device Press the Input button Adjusting the screen size and focus Projector placement angle adjustmentsTo adjust the horizontal angle, use the tilt adjuster Basic operations Using handy features Using auto settingCorrecting the keystone distortion Manual adjustments and settings Using handy features Press the remote control’s Freeze button Press the remote control’s Mute buttonCutting off the picture temporarily Mute Freezing the image Freeze How to use the menus Using the menus Image adjustment menu Using the menu Display setting menuScreen size No signal Default setting menuSets the lamp power Low Standard Auto Version Firmware version Note Displaying Information Status display Lamp replacement When the lamp is brokenAbout lamp Lamp replacement Lens cleaning Lens and main unit cleaningMain unit cleaning Replacing cooling fans Power went out during use No powerTrouble indications Lamp went out during use, or won’t come on Before calling service personnel List of general specifications SpecificationsSpecification Separately sold product SVGA85 List of supported signals RGB signals List of supported signals DVI signals Specifications List of supported signals Y/PB/PR signals List of supported signals Video, S-Video signalsPin assignment of Computer terminal Pin arrangement for the DVI-D terminal D V I D Control terminal Main CommandsPin assignment Interface format