Toshiba TDP-MT200 Displaying Information Status display, Version Firmware version Note

Using the menu (Continued)

■Displaying Information (Status display)

This displays information about the input signal, lamp use time, etc.

“Yes”: displayed, “No”: not displayed

Item	Description	Computer	Y/PB/PR	Video	DVI
				S-video
Input	Input source name	Yes	Yes	Yes	Yes
Mode name	RGB input mode [Note 1]	Yes	No	No	Yes
H-resolution	Horizontal resolution (in dots)	Yes	No	No	Yes
V-resolution	Vertical resolution (in dots)	Yes	No	No	Yes
H-frequency	Horizontal sync frequency	Yes	No	No	Yes
V-frequency	Vertical sync frequency [Note 2]	Yes	No	No	Yes
Sync	Sync signal polarity [Note 3]	Yes	No	No	Yes
Signal format	Y/PB/PR signal format	No	Yes	No	No
Video mode	Color method of video signal	No	No	Yes	No
Lamp time	Time of lamp use [Note 4]	Yes	Yes	Yes	Yes
Lamp reset count	The count for lamp replacement	Yes	Yes	Yes	Yes
Total time	The total time that this projector is used	Yes	Yes	Yes	Yes
Version	Firmware version [Note 5]	Yes	Yes	Yes	Yes

Notes

1:The mode of supported RGB signals p.39 is shown.

2:Same as the refresh rate of the computer signal.

3:Sync signal polarity shown as P (positive) or N (negative) for [H/V].

4:Displays [Lamp time] as a measure of when the lamp should be replaced. (Cannot be used as a counter of guaranteed lamp time.) When the displayed time approaches 2,000 hours, consult with a store about getting a TLPLMT20 replacement lamp (sold separately) prepared.

5:[Version] shows the version of the projector’s internal control program. This version is referred to for customer service, etc.

Note

•The displayed information will not be refreshed if the status changes. To refresh the information, dismiss the display, then display it again.

32