Lens and main unit cleaning, Lens cleaning | Toshiba TDP-MT200

English Français Español Deutsch Italiano Português Svenska

Used Lamps

This projector’s lamps contain trace amounts of environmentally harmful inorganic mercury. Be careful not to break used lamps, and dispose of them in accordance with local regulations.

Lens and main unit cleaning

WARNING

•Request cleaning and maintenance of a ceiling-mounted unit from your projector dealership. Attempting to clean/replace the lamp at a high site by yourself may cause you to fall down, thus resulting in injury.

■Lens cleaning

• Clean the lens with a commercially available blower and/or lens cleaner.

• The lens is easily scratched, so do not rub it with hard objects, or strike it.

■ Main unit cleaning

• Clean the main unit after unplugging the power cord.

• Wipe dirt off the main unit gently with a soft cloth.

• If the soiling is severe, dip the cloth in a neutral detergent diluted in water, wring well, and gently wipe off the dirt, then finish up by wiping with a dry cloth.

●Replacing cooling fans

To maintain the performance, it is recommended that cooling fans should be replaced about every 2 to 3 years. Consult with your dealer for details.

Maintenance

35

Image 35

Toshiba TDP-MT200 Lens and main unit cleaning, Lens cleaning, Main unit cleaning, Replacing cooling fans, Used Lamps

Contents

TDP-MT200 USA only Safety Precautions Before Using Ventilation Important Safety InstructionsPower Sources Source of Light Water and Moisture Power-Cord ProtectionCleaning Heat Important Safety Instructions Servicing AccessoriesDamage Requiring Service Do not use the product in a closed installation state Replacement PartsSafety Check Save Original Packing Materials Power Supply Cord SelectionImportant Precautions Place and Manner of Installation Exemption Clauses Important Precautions Avoid Volatile Liquid Other Cautions and Informations Remote Control Batteries Contents Others Checking the package contents 108 11 Names of each part on the main unit Names of each part on the control panel and remote control Parts on the rear panel Remove the battery cover Insert the dry-cell batteries Preparing and using the remote controlLoading dry-cell batteries into the remote control Operating the remote control Screen As seen from above PlacementPlacement Styles Projection Distance and Size Before connection Connection Removing the lens cover Connecting the power cordTurning the power on Press the ON/STANDBY button again Turning the power on and offTurning the power off Press the ON/STANDBY button Press the Input button Turn on the powerBasic operations Activate the connected device Basic operations Projector placement angle adjustmentsAdjusting the screen size and focus To adjust the horizontal angle, use the tilt adjuster Correcting the keystone distortion Using handy featuresUsing auto setting Manual adjustments and settings Using handy features Freezing the image Freeze Press the remote control’s Mute buttonPress the remote control’s Freeze button Cutting off the picture temporarily Mute How to use the menus Using the menus Image adjustment menu Screen size Using the menuDisplay setting menu Auto Default setting menuNo signal Sets the lamp power Low Standard Version Firmware version Note Displaying Information Status display About lamp Lamp replacementWhen the lamp is broken Lamp replacement Replacing cooling fans Lens and main unit cleaningLens cleaning Main unit cleaning Lamp went out during use, or won’t come on No powerPower went out during use Trouble indications Before calling service personnel Separately sold product SpecificationsList of general specifications Specification SVGA85 List of supported signals RGB signals List of supported signals DVI signals Specifications Pin assignment of Computer terminal List of supported signals Y/PB/PR signalsList of supported signals Video, S-Video signals Pin arrangement for the DVI-D terminal D V I D Interface format Main CommandsControl terminal Pin assignment