POWER SUPPLY CORD SELECTION
If your line voltage is 220 to 240V, use one of the following types of cable.
Plug |
|
|
configuration Plug type | Line voltage | |
EURO | 220 | 240V |
UK | 220 | 240V |
Use a 5A fuse which is approved by ASTA or BSI to BSI362.
Always replace the fuse cover after changing the fuse.
Plug |
|
configuration Plug type | Line voltage |
Australian | 200 240V |
240V |
|
10A |
|
Switzerland 200 240V 240V
6A
North American 200 240V 240V
15A
Before Using
IMPORTANT PRECAUTIONS
Save Original Packing Materials
The original shipping carton and packing materials will come in handy if you ever have to ship your projector. For maximum protection, repack the set as it was originally packed at the factory.
Moisture Condensation
Never operate this unit immediately after moving it from a cold location to a warm location. When the unit is exposed to such a change in temperature, moisture may condense on the lens and the crucial internal parts. To prevent the unit from possible damage, do not use the unit for at least 2 hours when there is an extreme or sudden change in tempera- ture.
Place and Manner of Installation
•Do not place in hot locations, such as near heating equipment. Doing so could cause malfunction, and shorten the life of the projector.
•Avoid locations with oil or cigarette smoke. Doing so will dirty the optical parts, shortening their lives, and darkening the screen.
•Do not use this product in the upright position or tilt it up or down by more than 20° from level. Doing so may cause a failure or shorten the life of the product.
•Using this instrument near a TV or radio may cause interference to the images or audio sound. If this happens, move it away from the TV or radio.
•Moving the projector from a
•In a high altitude location where air is thin, cooling efficiency is reduced so use the pro- jector with [Fan mode] set to [High].
9
