Toshiba TECRA USB Sleep and Charge function, methods, disabled, function, function”, the computer, of the computer, Sleep and Charge, quickly even when, The battery depletes

TECRA A11/S11, Satellite Pro S500

USB Sleep and Charge function

For more information and settings, please refer to the Using the TOSHIBA USB Sleep and Charge Utility section in Chapter 4, Operating Basics.

Problem	Procedure
I cannot use the “USB	USB Sleep and Charge function may be
Sleep and Charge	disabled.
function”.	Select the “Enable USB Sleep and Charge”
	check box in the TOSHIBA Sleep and Charge
	utility to enable this function.
	When there is a current overflow of the external
	device connected to the compatible port, USB
	bus power (DC5V) supply may be stopped for
	safety reasons. When this happens, disconnect
	an external device if some external devices are
	connected. After that, turn the power of the
	computer ON/OFF to restore the function. If this
	function can not be still used even if only one
	external device is connected, stop using the
	external device because its current is over the
	acceptable value of this computer.
	Some external devices may not be able to use
	the “USB Sleep and Charge function”. In this
	case, please try one or more of the following
	methods.
	■ Select another mode.
	■ Turn OFF the computer while external
	devices are connected.
	■ Connect external devices after turning OFF of
	the computer.
	If this function can not be still used, change the
	setting to disable the function and stop using this
	function.
The battery depletes	If USB Sleep and Charge function is enabled,
quickly even when I	the computer’s battery will discharge during
turned OFF the power	hibernation or when the computer is turned off.
of the computer.	Connect the AC adaptor to the computer or
	disable the USB Sleep and Charge function.

User’s Manual 8-17