TECRA A11/S11, Satellite Pro S500

■The slot A is reserved for the first memory module. Use the slot B for expanded memory. If only one module is installed, use the slot A. When inserting or removing memory modules, use the A and B marked on the computer chassis to determine which slot is A and which is B.

■Align the grooves along the edges of the memory module with the locking tabs on the connector and insert the module into the connector firmly - if you find it difficult to install the memory module, gently prise the locking tabs outwards using the tip of your finger.

Please also ensure that you hold the memory module along its left and right hand edges - the edges with the grooves in.

8.Seat the memory module cover in place and secure it with one screw.Take care to ensure that the memory module cover is firmly closed.

1

2

1. Memory module cover

2. Screw

Figure 3-10 Seating the memory module cover

9.Install the battery pack - refer to Replacing the battery pack section in Chapter 6, Power and Power-Up Modes, if required.

10.Turn your computer over.

11.Turn the computer on and make sure the added memory is recognized - to confirmed it, Start -> Control Panel -> System and Security -> System icon.

Removing a memory module

To remove the memory module, follow the steps as detailed below:1.Shut down the computer - make sure the Power indicator is off

(refer to the Turning off the power section in Chapter 1, Getting Started, if required).

2.Remove the AC adaptor and all cables and peripherals connected to the computer.

3.Close the display panel.

4.Turn the computer upside down and remove the battery pack

(refer to Replacing the battery pack section in Chapter 6, Power and Power-Up Modes, if required).

User’s Manual

3-27