4 Replacement Procedures 4.24 LCD unit/FL inverter
4-74 [CONFIDENTIAL] TECRA A9/TECRA S5/TECRA P5/Satellite Pro S200 Maintenance Manual (960-633)
Installing the LCD unit/FL inverter
To install the LCD unit/FL inverter, follow the steps below and refer to Figure 4-43 to 4-45.
1. Install the LCD unit to the display cover and secure it with the following screws.
• M2×3C BIND screw ×4
2. Connect the LCD cable to the connector on the back of the LCD unit. Stick two glass
tapes in place.
3. Connect two cables to the FL inverter and install the FL inverter in place.
4. Stick two glass tapes on the FL inverter in place.
5. Pass the Bluetooth antenna cable and wireless LAN antenna cable through the
hole of the cover assembly.
6. Install the display rear cover while engaging the latches.
7. Apply loctite 425 to the screws.
8. Secure the LCD unit with the following screws and stick two mask seals in place.
• M2.5×6B FLAT HEAD screw ×2