Projection on the screen (Continued) | CONTENTS 27 | |
4 | Adjust the picture size by turning the | |
zooming ring. |
| |
| Turn to the right to enlarge the picture. |
|
| Turn to the left to reduce the picture. |
|
5 | Focus on the picture by turning the |
|
focusing ring. |
| |
| A still picture is recommended for focusing. |
|
Notes
•When changing the projecting angle, adjust the foot adjuster. 19
•When the screen image is distorted in keystone, press the KEYSTONE button on the remote controller. 29
•“ ” is displayed on the screen if the projector does not receive any signal from the connected equipment. Put the equipment in playback mode.
•Due to the lamp characteristic, flickers may occasionally occur in a picture. This is not malfunction of the unit.
•While operating the projector, “ ” may be displayed on the screen. This means that the operation cannot be completed.
•“
” is displayed on the screen if:
-The projector is too hot. Turn the projector off, and leave it for a while, and then turn it on again.
-The ambient temperature is too high, use the projector under moderately cold temperature.
•“ ” is displayed on the screen if the air filter is dusty, the ventilation is impaired. This may cause the temperature inside the projector to rise. Clean the air filter. 55
Operations