Toshiba TLP-SX3500 AUTO Menu, Multifunctional Settings continued, selected automatically

Multifunctional Settings (continued)

AUTO Menu

With the AUTO menu, the items shown in the table below can be performed. Perform each operation in accordance with the instructions in the table below.

MENU

MAIN	ADJUST
PICTURE-1	POWER OFF	0 min
PICTURE-2	SEARCH	TURN ON
INPUT	RESET
AUTO
SCREEN
OPTION
NETWORK
: SELECT

Item Description

Pressing the (or the ENTER) button performs the automatic adjustment.

■For an RGB signal

The vertical position (V POSITION), the horizontal position (H POSITION), the clock phase (H PHASE) and the horizontal size (H SIZE) will be automatically adjusted. And the aspect ratio (ASPECT) will be automatically selected.

Make sure that the application window is set to its maximum size prior to attempting to use this feature. Dark pictures may still be incorrectly adjusted. Use a bright screen when adjusting.

■For a video signal or s-video signal

The signal type mode best suited for the respective input signal will be

	selected automatically.
ADJUST	This function is available only when the AUTO is selected to the item
	“VIDEO” of the INPUT menu. For a component video signal, the signal type is
	identified automatically independently of this function.

■For a video signal, s-video signal or component video signal

The vertical position and horizontal position will be automatically adjusted.

■For a component video signal

The aspect ratio will be automatically selected.

The clock phase will be automatically adjusted.

memo This operation requires approximately 10 seconds, and the message “AUTO IN PROGRESS” is displayed during the operation.

memo This operation may not work well at some signals. If the picture becomes unstable (ex. a irregular picture, a color lack), please select the suitable mode to the item “VIDEO” of the INPUT menu.

Set the time using the / buttons. :

Long (max. 99 minutes) ￿ Short (min. 0 minute = DISABLE)

	AUTO	AUTO
	POWER OFF	POWER OFF
	ENABLE	DISABLE
POWER OFF	1min	0min
	ex.
	When the time is set to 1 to 99, the projector lamp will go off and the
	STANDBY/ON indicator begins blinking when the passed time with a proper
	signal (without no-signal and an unsuitable signal) reaches at the set time.
	Please refer to the section “Turning Off The Power”.
		(This table is continued to the following page.)

37