Power ON/OFF
WARNING • When the power is ON, a strong light is emitted. Do not look into the lens or vents of the projector.
NOTE • Turn the power on/off in right order. Please power on the projector before the connected devices. Power off the projector after the connected devices.
Turning On The Power
1Remove the lens cap.
2 | Set the power switch to [ ] (ON). | |
The STANDBY/ON indicator will light to solid orange. | ||
| Press the STANDBY/ON button. | |
3 | ||
The projector lamp will light up and the | ||
|
|
STANDBY/ON indicator will begin blinking green. When the power is completely on, the indicator will stop blinking and light green.
Use the LENS SHIFT buttons to shift the
4picture upward or downward.
Select an input signal according to the
5section “Selecting An Input Signal” of the following page.
STANDBY/ON
STANDBY/ON button / indicator
LASER INDICATOR
STANDBY/ON VIDEO RGB
+ | + | + |
LENS SHIFT | FOCUS | ZOOM |
– – –
STANDBY/ON
STANDBY/ON button
Power switch (ON position)
LASER INDICATOR
STANDBY/ON VIDEO RGB
+ | + | + |
LENS SHIFT | FOCUS | ZOOM |
– | – | – |
BLANK | ASPECT | LASER |
LENS SHIFT
buttons
Turning Off The Power
Press the STANDBY/ON button.
1The message “Power off?” will appear on the screen for approximately 5 seconds.
Press the STANDBY/ON button again while
2“Power off?” the message is visible. The projector lamp will go off, and the STANDBY/ON indicator will begin blanking orange. Then the STANDBY/ON indicator will stop blinking and light to solid orange when the lamp cooling is complete.
Switch the power switch to [O] (OFF).
3The STANDBY/ON indicator will go off.
4Attached the lens cap.
STANDBY/ON
STANDBY/ON button / indicator
LASER INDICATOR
STANDBY/ON VIDEO RGB
+ | + | + |
LENS SHIFT | FOCUS | ZOOM |
– – –
STANDBY/ON
STANDBY/ON button
Power switch (OFF position)
23
