Lamp (continued)
Replacing The Lamp
If the indicators or a message prompts you to replace the lamp, replace the lamp as soon as possible.
Turn off the projector, and unplug the power cord. Allow the lamp bulb to cool for at
1least 45 minutes.
Contact your dealer to prepare a new lamp. Tell the dealer your lamp type number.
2If the projector is mounted on the ceiling, or if the lamp has broken, also ask the dealer to replace the lamp.
In the case of replacement by yourself,
After making sure that the projector has cooled
3adequately, slide the knob of a lamp cover lock as shown in the Figure. Then, one side of the lamp cover is raised. Pull up the lamp cover and remove it, as shown in the Figure.
Lamp cover | Lamp cover | |
knob | ||
|
Unscrew the 3 screws, and slowly pull out the lamp
4 by the handle. Be careful not to touch the inside of Screws the lamp case.
Insert the new lamp, and tighten the 3 screws firmly
5to lock it in place.
PC
CO LAMP
Interlocking the 2 tabs of the lamp cover to the
6 projector, put the lamp cover on the projector. Then Tabs 
push the point of the lamp cover to fix it, as shown in
the Figure. Make sure that the lamp cover does’t
come up.
Turn on the projector, and reset the lamp timer.
7 (1) While the projector running, press the MENU button to open the menu.
(2) Choose the “OPTION” on the menu using the 
/ 
button, then press the 
button or ENTER button.
(3) Choose the “LAMP TIME” using the 
/ 
button, then press the 
button or RESET button.
(4) Choose the “RESET” using the 
button.
memo When the lamp has been replaced after the message of "THE POWER WILL TURN OFF AFTER 0hr." is displayed, complete this operation within 10 minutes of switching power on.
memo Incorrectly resetting of the lamp timer (resetting without replacement, or neglect of resetting after replacement) will result in incorrect message functions.
46
