Toshiba TLP-SX3500 user manual OPTION Menu, Multifunctional Settings continued, Off On

Multifunctional Settings (continued)

OPTION Menu

With the OPTION menu, the items shown in the table below can be performed. Perform each operation in accordance with the instructions in the table below.

MENU
MAIN	VOLUME	16
PICTURE-1	SPEAKER	TURN ON
PICTURE-2	IR REMOTE	1: 2:	3:
INPUT	IR REMOTE ID	ALL
AUTO	LAMP TIME	1234 h
SCREEN	FILTER TIME	4321 h
OPTION	SERVICE
NETWORK	RESET
: SELECT

Item Description

Adjust the volume using the / buttons. :

VOLUME

High ￿ Low

Select the TURN ON or the TURN OFF using the / buttons. :

SPEAKER TURN ON ￿ TURN OFF

When the TURN ON is selected, the built-in speaker works.

	Select a remote sensor using the		/	button (1), then switch		OPTION
	it using the ENTER button (2). :					IR REMOTE
						1 : FRONT
IR REMOTE	(1) 1 : FRONT ￿ 2 : TOP ￿ 3 : REAR			(2) ￿ (Off) ￿ ￿ (On)
						2 : TOP
	memo A sensor cannot be turned off when the other two are off.					3 : REAR
						ENT
	Always at least one sensor is on.
	Select a number as an ID number for remote control using the				/	buttons. :
	ALL ￿ 1 ￿ 2 ￿ 3
	The projector is controlled by the remote control whose ID CHANGE switch is
IR REMOTE ID set into the position of the same number as this number. When the ALL is
	selected, the projector is controlled by a remote control irrespective of the
	position of the ID CHANGE switch.
	memo Please refer to the section “Using The Remote ID Feature”.
	Pressing the button or RESET button displays the LAMP TIME menu.
	Select the RESET using	button to reset the timer. :
	RESET ￿ CANCEL
LAMP TIME	Selecting the RESET resets the count of the lamp timer to 0.
	memo Perform this function only when you have replaced the lamp. The lamp
	timer counts the used time of the current lamp, to display the messages about
	the lamp. Incorrect performing causes incorrect operation of the messages.
	memo About replacing the lamp, please refer to the section” Lamp”.

Pressing the button or RESET button displays the FILTER TIME menu.

Select the RESET using button to reset the timer. :

RESET ￿ CANCEL

Selecting the RESET resets the count of the filter timer to 0.

FILTER TIME memo Perform this function only when you have cleaned or replaced the air filter. The filter timer counts the used time of the air filter after cleaning or replacement, to display the messages about the air filter. Incorrect performing causes incorrect operation of the messages.

memo About caring for the air filter, please refer to the section “Air Filter”.

(This table is continued to the following page.)

41