Troubleshooting (continued)
Related Messages (continued)
Message | Description | |
|
| |
REMINDER | The time the filter timer has counted has reached the | |
*** HRS PASSED AFTER THE LAST | ||
FILTER CHECK. | interval time set by the "FILER MESSAGE" of | |
"SERVICE" item in the OPTION menu. | ||
FILTER MAINTENANCE IS | ||
Please clear or change the air filter by referring to the section | ||
ESSENTIAL TO REMOVE WARNING | ||
MESSAGE, RESET FILTER TIMER. | “Air Filter”. After caring for the air filter, please be sure to reset | |
the filter timer. | ||
SEE MANUAL FURTHER INFO. | ||
| ||
|
| |
| The internal portion temperature is rising. | |
PLEASE CHECK THAT THE | Please turn the power OFF, and allow the unit to cool down at | |
FILTER HAS BEEN CLEANED. | least 20 minutes. After the projector has sufficiently cooled | |
FAILURE TO CLEAN MAY | down, please make confirmation of the following items, and | |
then turn the power on again. | ||
RESULT IN DAMAGE TO THE | ||
• Is there blockage of the air passage aperture? | ||
PROJECTOR. | ||
• Is the air filter dirty? | ||
SEE MANUAL FURTHER INFO. | ||
• Does the peripheral temperature exceed 35°C? | ||
| • Is the filter cover in place? | |
|
| |
NO INPUT IS DETECTED | There is no input signal. | |
Please confirm the signal input connection, and the status of the | ||
ON *** | ||
signal source. | ||
| ||
|
| |
| The horizontal or vertical wavelength of the inputted | |
SYNC IS OUT OF RANGE | signal is outside of the response parameters of this | |
unit. | ||
ON *** fH *****kHz fV *****Hz | ||
Please confirm the specs for this unit or the signal source | ||
| ||
| specs. | |
|
|
50
