| Controlling the projector by using |
|
|
| 73 |
|
|
|
|
You can also control the projector by entering the command from a computer via
Signal assignment of |
|
|
| Interface format |
|
|
|
|
| ||||
1 | 2 |
|
|
|
| 1. | Communication |
|
|
| |||
4 |
| Pin No. |
| Signal | Description |
|
| method | 9600 bps, No parity, Data length: 8 bit, | ||||
|
| 1 |
| RXD | Receiving data |
|
|
| Stop bit: 1 bit |
|
|
| |
3 | 5 | 2 |
| CTS | Consent to send |
|
|
|
|
|
|
|
|
| 2. | Communication | STX (02h) | Command (3 bite) | ETX (03h) |
| |||||||
|
| 3 |
| DSR | Data set ready |
| |||||||
|
|
|
|
| format |
|
|
|
|
| |||
|
|
|
|
| One command only can be used in one communication. | ||||||||
6 | 8 | 4 |
| GND | Signal ground |
|
| ||||||
5 |
| RTS | Request to send | 3. | Data format | Command shall be composed of alphanumeric | |||||||
| 7 |
| |||||||||||
| 6 |
| N.C | No connection | |||||||||
CONTROL |
|
|
|
| characters of ASCII description. | ||||||||
|
|
|
|
|
|
|
|
|
|
| |||
|
| 7 |
| TXD | Sending data |
|
|
| Use only capital letters. | ||||
|
| 8 |
| N.C | No connection |
|
|
|
|
|
|
|
|
|
|
|
|
|
| 4. | Return value | Acknowledge | ACK (06h) |
|
| ||
|
|
|
|
|
|
|
|
| Not Acknowledge | NAK (15h) |
|
|
Classification | Items/Status |
| Selection | Adjustment | Analog RGB(1) | Digital RGB | Video | Y/PB/PR | Camera |
| Command | Command | Analog RGB(2) | ||||||
Power | On |
| PON | - | Yes | Yes | Yes | Yes | Yes |
| Off (with confirmation message) | POF | - | Yes | Yes | Yes | Yes | Yes | |
| Shut Down (without confirmation message) | PSD | - | Yes | Yes | Yes | Yes | Yes | |
Normal (RS | DOF | - | Yes | Yes | Yes | Yes | Yes | ||
Picture | Contrast |
| VCN | Yes | Yes | Yes | Yes | Yes | Yes |
| Brightness |
| VBR | Yes | Yes | Yes | Yes | Yes | Yes |
| Sharpness |
| VSH | Yes | - | - | Yes | Yes | Yes |
| Camera gain | Increase | CGU | - | - | - | - | - | Yes |
|
| Decrease | CGD | - | - | - | - | - | Yes |
| Picture mode | Bright | MVB | - | Yes | Yes | - | - | - |
|
| True color | MVP | - | Yes | Yes | - | - | - |
Notes
• When commands are transmitted serially, wait the reply of the projector (acknowledge or not acknowledge) before sending a next command.
• Adjustment commands include "ARG" (increase adjustment value) and "ALF" (decrease adjustment value). For usable items (marked "Yes"), send after the selection command.
• The "Yes" marks in the input source columns indicate that that command can be used.
Continued
Others