RECORDING A TV PROGRAM (Continued...)
2Press the SP/SLP selector button to select the desired tape speed SP or SLP.
The counter and SP or SLP will appear on the screen for
"" will appear on screen for about 4 seconds and the REC indicator will blink to continue pause mode.
NOTE: The pause function will be released after 5 minutes to prevent damage to the tape or the VCR. The VCR will change to the STOP mode.
about 4 seconds.
00 : 00 : 00 SP
3Press the direct channel selection buttons or the CHANNEL or button to select the channel to be recorded.
Example: Press 012 for “12”.
Example: Press 22 for “22”.
RECORDING ONE PROGRAM WHILE WATCHING ANOTHER
While the VCR is recording, press the TV/VCR selector button to select the TV position.
The TV/VCR indicator will go off and recording will continue.
Select the TV channel you want to watch by using the TV channel selector.
NOTE: Some CATV hookups do not permit viewing one channel while recording another. See pages 12,13.
Example: Press 110 for “110”.
4 Press the REC button.
" " will appear on the screen for about 4 seconds and the REC indicator will light.
CH 110
TO PREVENT AN ACCIDENTAL RECORDING
After recording, break off the erase prevention tab if you do not wish to record over the tape.
Screwdriver
NOTE: Since the VCR has its own TV tuner, it is not actually necessary to have the TV turned on in order to make a recording. Turning on the TV merely allows confirmation of the proper channel settings on your VCR.
TO STOP RECORDING
Press the STOP button to stop recording.
" " will appear on screen for about 4 seconds.
Erase prevention tab
TO RECORD AGAIN
Cover the hole with adhesive tape.
Be careful the tape does not extend past the edges of the cassette housing.
TO STOP RECORDING TEMPORARILY
Press the PAUSE/STILL button to avoid recording unwanted material. Press again or press the REC button to continue the recording.
Adhesive tape
19