TP-Link TD-W8970N manual Layer2 Interface

TD-W8970NWireless N ADSL2+ Modem Router User Guide

This Advanced Setup section mainly introduces how to configure the Router for adequate use. The detailed explanations for each subsection are provided below.

)Note:

To completely configure the WAN Interface, you need to first select the Layer2 Interface (4.4.1 Layer2 Interface) according to the connection ISP provides you, and then to select the type of the connection (4.4.2 WAN Service) for the further configuration.

4.4.1 Layer2 Interface

Choose “Advanced Setup”Æ“Layer2 Interface”, and you can select WAN Service Interface (layer2 interface) over ATM interfaces or ETH interface.

¾ATM Interface: Configure the Router to access Internet as an ADSL user. ISP provides you VPI (Virtual Path Identifier), VCI (Virtual Channel Identifier) settings and the DSL Interface with RJ11 connector. (Figure 2-1)

¾ETH Interface: Configure the Router to access Internet as an Ethernet user. ISP provides you Broadband Internet Service and the Ethernet Interface with RJ45 connector.

4.4.1.1ATM interface

Choose “Advanced Setup”Æ“Layer2 InterfaceÆATM interface”, you can Configure ATM interfaces on the screen below.

16