TP-Link manual 5.9System Tools, Firmware, TL-R402M Cable/DSL Router User Guide

TL-R402MCable/DSL Router User Guide

1. Enter the following data:

¾Destination IP Address - The Destination IP Address is the address of the network or host that you want to assign to a static route

¾Subnet Mask - The Subnet Mask determines which portion of an IP address is the network portion, and which portion is the host portion

¾Gateway - This is the IP address of the gateway device that allows for contact between the router and the network or host

2.Click the Enable checkbox.

3.Repeat steps 1-2 until you are finished.

4.If you are finished. Click the Save button to save it.

To modify an existing entry:

1.Modify the entry’s Destination IP Address, Subnet Mask and Gateway.

2.Click the Save button.

To delete an existing entry:

1.Select the entry as you desire and make all of its fields blank.

2.Click the Save button.

To delete all the entries:

1.Click the Clear All button.

2.Click the Save button.

Note:

You can set up to 8 entries.

5.9System Tools

-System Tools y Firmware

y Factory Defaults y Reboot

y Password y Log

Figure 5-30 System Tools menu

There are five submenus under the System Tools menu (shown in Figure 5-30):Firmware, Factory Defaults, Reboot, Password and Log. Click any of them, and you will be able to configure the corresponding function. The detailed explanations for each submenu are provided below.

5.9.1 Firmware

The page (shown in Figure 5-31)allows you to upgrade to the latest version of firmware for the router.

37