TP-Link TL-SG3424 manual Rear Panel, Port Feature

L2 Managed Switch

LED	Status		Indication
	On		The remaining PoE power≤7W.
PoE Max	Flashing		The remaining PoE power keeps ≤7W after this LED is
			on for 2 minutes.
	Off		The remaining PoE power≥7W.
		On	The port is supplying power normally.
	Green
		Flashing	The supply power exceeds the correponding port's
10/100/			maximum power.
		On	Overload or short circuit is detected.
1000 Mbps	Yellow
		Flashing	Power-on self-test has failed.
	Off		No PoE power supply is provided on the port.

Note: TL-SG3216/TL-SG3424/TL-SG3424P switch features some “Combo” ports. A

“Combo” port consists of a RJ45 port and a SFP port, and the two ports share the same LED.

Port Feature

Model	10/100/1000Mbps	Console Port	SFP Port
	RJ45 Port
TL-SG3210	8	1	2
TL-SG3216	16	1	2
TL-SG3424/TL-SG3424P	24	1	4

10/100/1000Mbps Port

Designed to connect to the device with a bandwidth of 10Mbps, 100Mbps or 1000Mbps. Each has a corresponding 1000Mbps LED.

Console Port

Designed to connect with the serial port of a computer or terminal for monitoring and configuring the switch.

SFP Port

Designed to install the SFP module. TL-SG3216/TL-SG3424/TL-SG3424P switch features some SFP transceiver slots that are shared with the associated RJ45 ports. The associated two ports are referred as a “Combo” port, which means they cannot be used simultaneously, otherwise only SFP port works. TL-SG3210 features two individual SFP ports.

Note: For TL-SG3216/TL-SG3424/TL-SG3424P, when using the SFP port with a 100M module or a gigabit module, you need log on to the GUI (Graphical User

Interface) of the switch and configure its corresponding Speed and Duplex mode on

Switching→Port→Port Config page. For 100M module, please select 100MFD while select 1000MFD for gigabit module. By default, the Speed and Duplex mode of SFP port is 1000MFD. TL-SG3210 supports 1000M SFP module connection only.

■■ Rear Panel

The rear panel of TL-SG3210 is shown as the following figure.

04 Introduction