Trango Broadband TrangoLink-10 CLI Command freq ch pol, Rfrxth ism, Power setism max min dBm

Configuration Basic Diagnostics

Parameter	Description	Associated Page and Notes
		set mir [<downstream kbps, 100..10000>
		<upstream kbps, 100..10000>]
Downstream	Current throughput from Master Unit to	Informational Parameter
Throughput	Remote Unit.
Upstream	Current throughput from Remote Unit to	Informational Parameter
Throughput	Master Unit.
Active Channel	Current RF channel and polarization (v)ertical or	Configuration page
	(h)orizontal.	CLI Command: freq <ch> <pol>
RF RX Threshold	Specifies the receiver sensitivity of the radio.	Advanced page
	This user-changeable parameter is a powerful	CLI Command:
	tool that is useful for mitigating the effects of	rfrxth <ism > <-90-85-80-75-70-65>
	interference. The radio will not process any
	signals receieved that are weaker than the RF
	RX threshold.
RF TX Power	Transmit power of the radio (not including	Advanced page
	antenna gain)	CLI Command:
		power <setism> <max min dBm>
Channel Table	Assigns channel numbers to actual	Advanced page
	frequencies of operation. The default channels	CLI Command:
	1 – 6 are assigned to ISM band. Note: All	freq writechannel [<ch#> <freq>] ...
	channels may be re-assigned as desired by the
	user. Default settings allow optimum use of
	the available spectrum. The frequencies
	assigned on the Master Unit must match those
	on the Remote Unit.
Broadcast Packet	This switch (0) enables/disables the blocking of	Configuration page
Filter	Ethernet control packets, except ICMP and ARP,	CLI Command:
	to reduce the amount of unnecessary overhead	sw 0 [<on off>]
	introduced to the wireless link
Remarks	User definable radio information (i.e. customer	Informational Parameter
	name, address of installation, and so on).	CLI Command:
	Maximum 28 characters can be stored.	remarks <remarks>
Eth In	Eth In: Counter for Ethernet packets that	Informational Parameter
	entered via the Ethernet port of the radio.
Eth Out	Counter for Ethernet packets that exited via	Informational Parameter
	the Ethernet port of the radio.
RF In	Counter for Ethernet packets that entered	Informational Parameter
	over-the-air into the radio.
RF Out	Counter for Ethernet packets that exited over-	Informational Parameter
	the-air out of the radio.

Trango Broadband Wireless — TrangoLINK-10 User Manual Rev. E 3.0 page 14