Trango Broadband TrangoLink-10 user manual Remote Unit System Information, Set defaultopmode onoff

Configuration Remote Unit System Information

Remote Unit System Information

Log into the RU and the System Information page will appear. The user can change many of these parameters.

Note: When changing settings, it is usually necessary to click the Save and Activate Settings Button in order to update the radio’s flash memory. If you do not, the setting will be lost the next time the radio is rebooted or power cycled.

Table 2: Reference Table of Remote Unit System Information Parameters

Parameter	Description	Associated Page and Notes
Hardware Version	Hardware version is factory-set and cannot be	Permanent with Hardware
	changed by user.
FPGA Version and	These parameters provide information about	Changes with FPGA upgrade. See
Checksum	the current FPGA firmware loaded in the	subsequent Release Notes on web site.
	radio.
Firmware Version	The Firmware version is the initial four	Changes with firmware upgrade. See
	characters of this string. (i.e. 1p60 = 1.60 )	website for latest firmware version and
		release notes.
Device ID	MAC address of the radio.	Permanent with Hardware
Opmode	Current operation mode of the radio. “On”	Configuration page.
	indicates transmitting. “Off” indicates not	Note: in order to change radio from
	transmitting.	Opmode “On” to Opmode “Off,” you must
		change the default Opmode to “Off” and
		reboot the radio.
Default Opmode	Determines the Opmode (“ON” or “OFF”) of the	Configuration page
	radio after reboot/power cycle. When the	CLI Command:
	parameter is set to “ON”, the radio will progress	set defaultopmode [<onoff>]
	into Opmode “ON” 30 seconds after
	reboot/power cycle. Note: If radio startup is
	interrupted within 30 seconds after reboot (by
	opening a Telnet session) the radio will remain in
	Opmode “OFF.”
System Up Time	Time since radio was last rebooted or power	Informational Parameter
	cycled.
Radio Temperature	Current internal temperature of radio.	Informational Parameter
[IP]	IP, subnet, and Gateway address of radio used to	Configuration page
[subnet]	manage the radio.	Note: Changing the IP of the radio could
[gateway]		cause loss of management connectivity.
		CLI Command:
		ipconfig [<ip> <subnet> <gateway>]
Master ID	MAC ID of the MU that is associated to this RU.	Informational Parameter
Status	Status of Master Unit: Connected (wireless	Informational Parameter
	link established), or Disconnected (wireless
	link not established).
RSSI	Relative Signal Strength Indicator. Displays	Informational Parameter
	signal strength received from the RU to the
	MU. A “?” indicates MU is not connected.
TFTPD Status	TFTP daemon status (on or off). TFTPD should	Configuration page
	be turned on to import a file (such as new	Note: This is used in firmware upgrade.
	firmware) into radio’s TFTP buffer. Default is	CLI Command
	off.	tftpd [<on off>]
Telnet Port	User changeable telnet port of radio.	Configuration page
RF TX Power	Transmit power of the RU not including antenna	Informational Parameter
	gain. The RU’s transmit power will
	automatically be adjusted to result in receive
	signal strength at the MU to approximately
Trango Broadband Wireless — TrangoLINK-10 User Manual Rev. E 3.0		page 15